assuming it's a mouse with a roller ball in it...flip it over and look for a way to remove the roller ball. You'll be shocked & appalled at the gunk that has built up over time. Carefully clean the roller ball & the wheels on the inside and you should see a marked improvement.
Telling myself the same lies that I told myself back home
balcony girls wrote:. .and it's making me CRAZY . . ! !
. . I am soooooo tired of dragging and pushing this thing all over my desk just to get to the top of my screen . . . ! !
. . is there any " quick fix " for it . . . short of a few dunks in the toilet. . ? ?
First thought: Sounds like a personal problem BG!
Second thought: If it is a regular mouse, turn it over and take the roller ball out. You should just have to turn the piece of plastic aorund it, and then pull it out. Inside the mouse, the roller ball sits in a cradle with three bars on it's sides. These bars are what translates the movement of the ball into the signal for the mouse. They can get covered with gunk, so take a pencil eraser, paper clip, anything that will fit and scrape the gunk off. Make sure you shake that stuff out of your mouse when done. Put the ball back in and put the plastic piece back in and turn it to lock it in. It should work fine.
You might get yourself some of those Computer Wipes, they sell them in most electronics departments of stores. Or you can use rubbing alcohol on a paper towel or Qtip (don't saturate it, drips can cause trouble). Clean the ball and the inside of the mouse as good as possible.
If it's an optical mouse (with a little, usually red, light coming out of the bottom), it might be a dust problem, or a problem with the surface. Shiny surfaces don't work too well with optical mice. Also, the surface should have a texture of some sort, so the mouse can discern movement. Check the little hole where the light is for dust. You can use canned air to blow your mouse.
SharkOnLand wrote:Mouse balls should always be handled with care...
Also, the surface should have a texture of some sort, so the mouse can discern movement. Check the little hole where the light is for dust. You can use canned air to blow your mouse.
If its a roller ball mouse, just try taking out the roller and blowing the dust out. Mine used to get little dust bunnies in before I switched to optical/laser meese.
Second alternative ... get a new one. They cost less than a days booze in Waikiki